The Official enkeivette dyno pool
Time to put yo money where yo mouth is. Ever wonder how much HP enkeivette's blown C3 makes? So has everybody else. Now he's looking for an intercooler. Then, at some dyno day he's gonna run it.
The rules:
1 - $10 gets you in the pool.
2 - The closest number to PEAK HP wins, whether over or under.
3 - Just reply to this thread with your intent to participate and your estimate. You can change your mind once up until midnight of the day before the pull. All participants will be aggregated into this thread.
NOTE: enkei doesn't have an intercooler yet or a dyno day scheduled.
ENGINE SPECS: (current state sans intercooler)
* 383ci SBC
* 9:1
* Procharger D1SC 4" pulley (13lbs of boost hot air), K&N filter
* Forged Scat Crank
* Forged Scat 6" Rods
* Forged Aluminum SRP Pistons
* AFR 195cc Aluminum Angle Plug Heads w/8032 Upgrade
* Comp Hyd Roller Cam & Lifters .576 in .594 ex Lift 239in 245ex Duration @ .05
* Comp Chromeoly Pushrods
* Harland Sharp 1.65 Full Roller Rockers
* Edelbrock Victor Jr
* MSD Pro Billet HEI (24 degrees total timing/ 91 octane)
* Mighty Demon 750 Annular
* Hamburger 7 qt oil pan baffled
* ProForm aluminum high flow water pump
________________________________________
PARTICIPANTS:
BADDASSC6 540WHP
enkeivette 550WHP
Leedom 565WHP
joedls 582WHP
Vettezuki 605WHP
SeanPlunk 625WHP
__________________
Motorgen on To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. (active)
Motorgen Project Car To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. (back burner)
Last edited by Vettezuki : 01-19-2010 at 11:06 AM.
|