|
|
 |
|
04-09-2007, 10:01 PM
|
#11
|
|
I, Vettezuki
Join Date: Feb 2006
Posts: 14,754
|
A wee update
Well, basically everything is great . . .except the cooling fans don't come on at their trigger temps. We're pretty much down to it being the computer itself (apparently it uses a pull up resistor for triggering the fan relay) or . . . gasp. . . the wiring harness. We've tested the relays, ground, and the fans themselves work fine. In fact, oddly, they come on during a cold start for about one minute, but then never come on again. We've tried 2 totally different custom programs and they behave exactly the same. The makers of the harness are going to send a new computer. Hopefully that works, if not, it's really starting to look like there is some mistake in the harness itself. I know we could work around it bypassing the computer completely and using a temp switch but I can't stand not knowing why something relatively simple isn't working as it should.
Other than that, it the little bit I've gotten to drive it, it's awesome. Pretty vicious, but still streetable. I'm a very patient person,  but I really want to see this phase come to an end. . .
__________________
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(active)
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(back burner)
|
|
|
|
|
05-07-2007, 09:31 PM
|
#12
|
|
I, Vettezuki
Join Date: Feb 2006
Posts: 14,754
|
Aha!
Found the problem with the cooling fans. Turns out it was nothing more than the pin out on the fan relay connector was reversed. The good news is that it took about 3 minutes to fix . . . unfortunately it took me about 2 months to find. 
Now that that's out of the way I can finally turn my attention to buttoning up the remaining issues before scheduling a session with our lovely CA engine swap referee.
They are:
- charging A/C
- installing speedo and tach
- installing new Alt (investment in reliability as old one was putting out somewhat low voltage, then just about everything will be new or pretty new)
- finding out why the AIR pump relay isn't getting power; might just be a bad fuse link
- figure out what's drawing major current at all times
- dyno test/tune to make sure she's running clean
That being said, I got drive her a fair bit on Saturday. . . Wow, even in the currently somewhat un-tuned state, it's just a different world. Torque everywhere as well as rev happy . . . and when you get into the revs, watch out. She pulls hard beyond where I lose my nerve.
I do look forward to the 5 link rear suspension and modern wheels/tires for stability's sake. Right now I really have to be paying attention when I get anywhere near the go pedal.
Pics and videos within a week.
__________________
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(active)
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(back burner)
|
|
|
|
|
12-02-2007, 04:00 AM
|
#13
|
|
Super Moderator
Join Date: Dec 2007
Posts: 6,850
|
How does it handle with 17s? What size tires did you end up going with?
I feel your electric fan relay pains, I've been through 2 broken relays in the last 3 months. Just ordered a Painless kit, plan to install it tomorrow. On at 185, off at 170.
|
|
|
|
|
12-02-2007, 04:03 AM
|
#14
|
|
I, Vettezuki
Join Date: Feb 2006
Posts: 14,754
|
Quote:
|
Originally Posted by enkeivette
How does it handle with 17s? What size tires did you end up going with?
|
In comparison to the original 15s . . . uh, no comparison. I went with Nitto NT 450s, which have proven to be quite a good tire, especially for "just" a 255 section width. Since you last rode in it, I put in the VB&P Dual Mount Mono Spring in rear and 550lb Coil Springs up front. It's an overall huge difference. I'm considering putting in a 6 point cage to really stiffen it up, but I'm not sure yet. Hope you can come out to the track with us next time.
__________________
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(active)
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(back burner)
|
|
|
|
|
12-02-2007, 04:07 AM
|
#15
|
|
Super Moderator
Join Date: Dec 2007
Posts: 6,850
|
Awesome documentation. That rack and 'peanut' looks sexy, I want one for mine... maybe I'll steal yours when you're not lookin. 
Yeah, I'll bet the difference in handling was shocking. Mine went from handling like a Jeep to handling... well you've been in my car. Sway bars too! I'm running the biggest bars that I could find, Fast Corvette up front and Addco out back. |
|
|
|
|
12-02-2007, 04:14 AM
|
#16
|
|
I, Vettezuki
Join Date: Feb 2006
Posts: 14,754
|
Quote:
|
Originally Posted by enkeivette
Awesome documentation. That rack and 'peanut' looks sexy, I want one for mine... maybe I'll steal yours when you're not lookin.
Yeah, I'll bet the difference in handling was shocking. Mine went from handling like a Jeep to handling... well you've been in my car. Sway bars too! I'm running the biggest bars that I could find, Fast Corvette up front and Addco out back. |
I know where you live. I love the feel of a manual rack. I wish it were perhaps just a touch faster ratio. . . maybe a smaller steering wheel will give the feeling I'm looking for. But now we're talking about details.
__________________
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(active)
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(back burner)
|
|
|
|
|
04-24-2008, 10:27 PM
|
#17
|
|
Member
Join Date: Mar 2008
Posts: 91
|
Wow.... Nice work & i'm certain it'll move!
|
|
|
|
|
04-24-2008, 10:53 PM
|
#18
|
|
I, Vettezuki
Join Date: Feb 2006
Posts: 14,754
|
Quote:
Originally Posted by anthonydalrymple
Wow.... Nice work & i'm certain it'll move!
|
You should see my 60' burnout. I'm pretty sure your supposed to go forward, but I haven't worked that out so well yet  On street tires at Fontana, I average 13.4 @ 109 with 2.4 60'. My best of 13.2 @ 111 is still faster than Seans 04' Cobra though. Something I "occasionally" remind him of. 
__________________
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(active)
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(back burner)
|
|
|
|
|
04-25-2008, 11:24 AM
|
#19
|
|
Neanderthal
Join Date: Mar 2008
Posts: 5,320
|
Quote:
Originally Posted by Vettezuki
You should see my 60' burnout. I'm pretty sure your supposed to go forward, but I haven't worked that out so well yet On street tires at Fontana, I average 13.4 @ 109 with 2.4 60'. My best of 13.2 @ 111 is still faster than Seans 04' Cobra though. Something I "occasionally" remind him of.
|
Nice runs. That's the first time I didn't want a FORD to hit the traps first. Still, damn nice runs. 
Funny thing here-a little brain damage-I have NEVER lost to a FORD and I'm a FORD guy. Been beat by Hemis, 440s, 427/454 Chevelle, 69 Camaro 302 (so he said) and 455 Judge, but never a FORD. I'm sure there are many FORDs out there faster than my Vette, just been lucky not to run against one.
Now in my 64 Fairlane Hipo 289- I raced a "REAL" 67 Vette L88-- blew my doors off. Got my 64 Vette a year later. Like I said - Brain Damage. 
__________________
64 Vette Roadster 400 ci
1990 F150 351 ci SuperCharged
48 Harley Pan Head 76 ci
2016 Nissan Altma
|
|
|
|
|
04-25-2008, 12:17 PM
|
#20
|
|
I, Vettezuki
Join Date: Feb 2006
Posts: 14,754
|
Quote:
Originally Posted by glenn64vette
Nice runs. That's the first time I didn't want a FORD to hit the traps first. Still, damn nice runs.
Funny thing here-a little brain damage-I have NEVER lost to a FORD and I'm a FORD guy. Been beat by Hemis, 440s, 427/454 Chevelle, 69 Camaro 302 (so he said) and 455 Judge, but never a FORD. I'm sure there are many FORDs out there faster than my Vette, just been lucky not to run against one.
Now in my 64 Fairlane Hipo 289- I raced a "REAL" 67 Vette L88-- blew my doors off. Got my 64 Vette a year later. Like I said - Brain Damage. |
FWIW, that Stang is Roush Stage something or other, and was on DRs. With DRs, I think it'd be a good heads up race.
__________________
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(active)
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(back burner)
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
