[jsup]

Hey guys, go to my facebook page, john supino, there's a bunch of photos of the install. I will be running around for the next couple days when I get back I'll post them here, it's just a function of time.

Fan us while you're there!

[enkeivette]

I've finally got my carb tuned to work right. But next time I'd go FI, something like this. Tuning my carb took years to do, plus an LM2, plus the cost of a cracked piston too.

[jsup]

Here's the ECU I have been talking about. The hardest part of doing any of this is finding the place to mount it.

I did some of the mounting work today. Still a lot more to do.

ECU Programming cable:


Wide Band Kit:

[jsup]

Mounting


ECU

[jsup]

Wide Band Module:

[jsup]

MSD Install. Again the hardest part of this crap is finding a place where it will all fit.

I put the MSD box under the battery box, I will have to modify the battery box to accommodate the MSD. My dremel is at my dads, have to get it tomorrow to modify the box. I went with the frame rail, as it is covered by the wheel well and runner board.

[jsup]

I managed to get 3 of the 4 mounting screws into the MSD box, think I'll just run a serial cable to the top.

Here's some shots:



You can see the ECU on top to the right.

This is where the ground from the battery ties to the frame, I grounded everything there, you can see the yellow connectors through the wires.



This is off the positive side of the battery, and is stock. I picked up the battery connections from here:



Here's the relay all hooked up:


Here's the wheel well back on so you can see how everything fits:

[jsup]

I managed to get 3 of the 4 mounting screws into the MSD box, think I'll just run a serial cable to the top.

Here's some shots:



You can see the ECU on top to the right.

This is where the ground from the battery ties to the frame, I grounded everything there, you can see the yellow connectors through the wires.



This is off the positive side of the battery, and is stock. I picked up the battery connections from here:



Here's the relay all hooked up:


Here's the wheel well back on so you can see how everything fits:

[jsup]

Here's the harness plugged into the ECU. Fits nicely.

[jsup]

I had to modify the battery support based on where I mounted the MSD. It was an easy job, I trimmed as little off as I had to. Not sure about the structural integrity issue, I'll look at that when I put everything back together as it's the last piece to go in.

Here's some pics:
No Battery Box:


Cut Away:




Mounted: