[Vettezuki]

Originally Posted by TimAT

That's just like the one I have. Instead of those press blocks with all the cutouts mine are just simple pieces of 1" thick steel. Those and a bearing splitter are about enough to do anything you need. The bearing splitter is just a block that has an edge and 2 big thru bolts. First one I came across on a search:

http://www.sears.com/shc/s/p_10153_12605_00970739000P


I'll tell you, I've had the whole thing off the ground- at full capacity of the ram, when the bearing pops loose, everything will jump. Makes you think about where you're standing.

I gots me one of them as part of the C3 rear end service it. When I rebuilt my trailling arms I "pushed out" the spindle by "hand", slightly bent a 1 inch press plate using a 4 foot red neck breaker. I'd prefer never to do that again.

[BRUTAL64]

Originally Posted by big2bird

Yep. Here ya go.

http://www.harborfreight.com/cpi/cta...temnumber=6834

Those usually come with the NEW press.

[Vettezuki]

Originally Posted by BRUTAL64

Those usually come with the NEW press.

I'm pretty sure they're separate, at least at HF.

[BRUTAL64]

Originally Posted by Vettezuki

I'm pretty sure they're separate, at least at HF.

Did you ask them?