[Vettezuki]

Originally Posted by 94cobra69ss396

Look on the front of the section I circled in orange where the arrow is pointing.

3310-11
2246

[BRUTAL64]

Originally Posted by Vettezuki

3310-11
2246

My first 3310 was 3310-1. So this one is fairly recent. As long as the main body is OK then it should work OK. I would of prefered Mech secondaries. I can even remember when Vac secondaries was all a person had to work with.

[enkeivette]

Any sort of schedule as to when the engine will be dropped in? At least the short block?

[Vettezuki]

Originally Posted by enkeivette

Any sort of schedule as to when the engine will be dropped in? At least the short block?

I have a colleague at work who actually had a V8 RX7. (Found out after our project.) He has and is giving us the cross member and trans mount for a SBC and TKO so we can check it out. Hopefully within this week we can begin test fitting.

[94cobra69ss396]

Originally Posted by Vettezuki

I have a colleague at work who actually had a V8 RX7. (Found out after our project.) He has and is giving us the cross member and trans mount for a SBC and TKO so we can check it out. Hopefully within this week we can begin test fitting.

We also need the oil pan from Joe.

[joedls]

Originally Posted by 94cobra69ss396

We also need the oil pan from Joe.

I'll have the oil pan and blower at my shop tomorrow. If needed, I can run them over to Ben's during the day sometime.

[Vettezuki]

Just an FYI.

I buy Torco Mach Fuel Accelerator in bulk. It's not an octane booster like others at all, but what Torco calls "Race fuel Concentrate". I know relatively small amounts of it (less than a quart to a full tank or more) work like a charm in my Vette. Anyway, just talked to their tech guy to get a little better idea of mixing ratio for 91. One quart to 10gal 91 equals about 102 octane. It ain't cheap when you buy it a quart at a time, but I have a 5 gal pale so it comes out to about $12.50 a quart; much cheaper than 50/50.

Anyway, we can figure tuning for 100 no problem.

[Vettezuki]

Originally Posted by joedls

I'll have the oil pan and blower at my shop tomorrow. If needed, I can run them over to Ben's during the day sometime.

I can pick them up from you late in the afternoon if that works.

[BRUTAL64]

Here's something interesting. I pulled a 3310 Holley out of stock. This is a BRAND NEW one and it's stamped 3310-10.

[94cobra69ss396]

Originally Posted by BRUTAL64

Here's something interesting. I pulled a 3310 Holley out of stock. This is a BRAND NEW one and it's stamped 3310-10.

The guy told us that he had just bought it. I took a look at the p/n on Phil's Holley the other day when we were working on his Jimmy. It too has 3310-10 and is about 8 or 9 months old that was purchased from Summit Racing.