I started installing the transfer case today. I went pretty good. I clearanced the body so that the case didn't hit the floor in a couple spots and then bolted it up to the trans. Next up is modifying the front mount for the fuel tank so that it clears the new case. I already pulled it off and cut a section off that wouldn't clear. I also cut a little peice of plate and welded it to the bracket. I still need to shape it and cut some areas of it to clear the tank but it's a start. Below are a few pictures of the bracket.
Another clearance issue I have is the tranmission crossmember because of my SAS. The new case sets the front driveshaft further rearward so the shaft will hit the crossmember. I'm going to have to figure out how I want to redo the crossmember.
The other thing I still need to do is measure to have new driveshafts made. I'll most likely do that before I do the crossmember so that they are being made while I making the crossmember.
