|
|
|
11-29-2012, 04:32 PM
|
#101
|
Fast & Filthy
Join Date: Jun 2008
Posts: 3,840
|
So I thought everything was good until last night when I drove the car to the store. About half way there it started to run a little rough again. This morning I took it for a drive and it was good for about 3 minutes and then started running rough again. I think that maybe one or two plugs might be bad and once they get some heat in them they start missing. I have a set of Autolite racing plugs that I ordered from Summit that I'm going to install tomorrow or Saturday and see if that is the issue. If it isn't then I'm at a lost.
|
|
|
11-29-2012, 04:33 PM
|
#102
|
pain's fun, hit me again
Join Date: Sep 2009
Posts: 6,264
|
Sounds like the PIP
__________________
Quote:
Originally Posted by Bruce Lee
Forget about winning and losing; forget about pride and pain. Let your opponent graze your skin and you smash into his flesh; let him smash into your flesh and you fracture his bones; let him fracture your bones and you take his life. Do not be concerned with escaping safely — lay your life before him
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Stopping the world!
|
|
|
11-29-2012, 05:04 PM
|
#103
|
Fast & Filthy
Join Date: Jun 2008
Posts: 3,840
|
What's the PIP?
|
|
|
11-29-2012, 05:50 PM
|
#104
|
pain's fun, hit me again
Join Date: Sep 2009
Posts: 6,264
|
Basically the sensor inside the distributor. Could also be the TFI module on the fender.
__________________
Quote:
Originally Posted by Bruce Lee
Forget about winning and losing; forget about pride and pain. Let your opponent graze your skin and you smash into his flesh; let him smash into your flesh and you fracture his bones; let him fracture your bones and you take his life. Do not be concerned with escaping safely — lay your life before him
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Stopping the world!
|
|
|
11-29-2012, 06:13 PM
|
#105
|
Fast & Filthy
Join Date: Jun 2008
Posts: 3,840
|
I have an MSD distributor so if you're talking about the magnetic pickup module inside it that has already been replaced not that long ago. I had an issue at one time where the car would cut out above 5000 rpms and I thought it was the pickup so I ordered a new one from Summit. One of the wires on the old one had worn through and I figured that was the issue. I still had the issue after replacing but it turned out to be because of the hole in the rubber elbow on the intake tube. Once I replaced it the car ran great.
I'll replace the plugs since I already have a new set and see if that resolves the issue. If it doesn't, what's the TFI module? Is it on the passenger side?
|
|
|
11-29-2012, 06:43 PM
|
#106
|
pain's fun, hit me again
Join Date: Sep 2009
Posts: 6,264
|
Yeah, under where the stock intake was. A PIP module is in ever distributor, stock or otherwise. You need to remove the upper bowl of the distributor to get under the piece that the rotor set in.
__________________
Quote:
Originally Posted by Bruce Lee
Forget about winning and losing; forget about pride and pain. Let your opponent graze your skin and you smash into his flesh; let him smash into your flesh and you fracture his bones; let him fracture your bones and you take his life. Do not be concerned with escaping safely — lay your life before him
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Stopping the world!
|
|
|
12-02-2012, 09:01 PM
|
#107
|
Fast & Filthy
Join Date: Jun 2008
Posts: 3,840
|
I had Phil test drive the Cobra tonight to see whether he thought what I was feeling was a missfire or a vibration and he says it's a vibration. My next step is to check the harmonic balancer to make sure the new one is 28oz and not 50oz. If it is then I guess from there the next step will be to check the flywheel. If both turn out to be correct then I guess the engine comes back out to have it rebalanced.
|
|
|
12-02-2012, 09:09 PM
|
#108
|
pain's fun, hit me again
Join Date: Sep 2009
Posts: 6,264
|
If you had the wrong weight on there that thing would shake the vehicle apart. It would be nearly undriveable.
__________________
Quote:
Originally Posted by Bruce Lee
Forget about winning and losing; forget about pride and pain. Let your opponent graze your skin and you smash into his flesh; let him smash into your flesh and you fracture his bones; let him fracture your bones and you take his life. Do not be concerned with escaping safely — lay your life before him
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Stopping the world!
|
|
|
12-03-2012, 07:46 AM
|
#109
|
Fast & Filthy
Join Date: Jun 2008
Posts: 3,840
|
It's not a horrible vibration. It just feels like a misfire but you feel it more under decel which I was too frustrated to notice before Phil drove it.
|
|
|
12-03-2012, 07:22 PM
|
#110
|
pain's fun, hit me again
Join Date: Sep 2009
Posts: 6,264
|
Thats not the balancer then, I would still check, but if it was you'd definitely know.
I'd check the pressure plate, motor mount, trans mount or possibly the pullies.
__________________
Quote:
Originally Posted by Bruce Lee
Forget about winning and losing; forget about pride and pain. Let your opponent graze your skin and you smash into his flesh; let him smash into your flesh and you fracture his bones; let him fracture your bones and you take his life. Do not be concerned with escaping safely — lay your life before him
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Stopping the world!
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|