Filed under:
Truck,
Government/Legal,
Recalls,
Safety,
Dodge,
Ram
Chrysler is issuing a
recall for the 2009 and 2010
Ram 1500 and
Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the
National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but
scroll down to see the official NHTSA notice.
Continue reading Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut
Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut originally appeared on
Autoblog on Mon, 08 Oct 2012 17:45:00 EST. Please see our
terms for use of feeds.
Permalink |
Email this |
Comments
More...
Official: Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinio
