Quote:
Originally Posted by Leedom
Great job Ron. I think we owe him a meal or something. If nobody else springs for it I will.
Can you say tight fitting over the Rack!
|
Thanks Adam but no need. I'm just helping out where I can.
I placed the engine as far back and as low as I could with leaving enough room to clear the rack. There is only about a 1/4 inch. I also wanted to make sure that the engine sat low enough that it would clear the stock hood if it had the engine from my Cobra in it. With the position of the engine in the Rx-Snake the hood line is about 1/2 inch closer to the engine than it is in my Cobra. I also mirrored the distance from the bell housing to the firewall to the Cobra so that the clearance between the engine and firewall was the same which was 2 1/2 inches.