Motorgen - Automotive Events, Meets, Cruises and Forums - View Single Post - One piece center console for a C3 Corvette

enkeivette · 03-29-2010, 10:43 PM

I've been working on this down here in San Diego on my coffee table. It sat in my Vette for a few months till I had time to add a second layer and pull it out.

Made it out of polyester fleece, matte and resin, Bondo and spot putty.

It provides a new home for my Mustang e-brake and my T56 short shifter. I'm running a Mustang e-brake because the stock cable location interferes with the yoke sticking out of my longer than stock T56 transmission. But the Mustang e-brakes pulley is off to the side, so it clears the yoke.

03-29-2010, 10:43 PM	#1
enkeivette Super Moderator Join Date: Dec 2007 Posts: 6,850 Tweet	One piece center console for a C3 Corvette I've been working on this down here in San Diego on my coffee table. It sat in my Vette for a few months till I had time to add a second layer and pull it out. Made it out of polyester fleece, matte and resin, Bondo and spot putty. It provides a new home for my Mustang e-brake and my T56 short shifter. I'm running a Mustang e-brake because the stock cable location interferes with the yoke sticking out of my longer than stock T56 transmission. But the Mustang e-brakes pulley is off to the side, so it clears the yoke.