This is from a site that does nothing but sell conversion parts for RX-7s.
"...The RX-7's layout and structure is well suited to engine conversions. The rotary engine's eccentric shaft centerline is way up in the center of the rotary engine, dictating a much higher transmission location than that of a piston engine. The net result is that Mazda designed the RX-7 with a HUGE transmission tunnel, big enough to fit even the monster T-56 6 spd manual transmission which was used in the Viper and Corvette. The rotary engine's low torque output required Mazda to use a very heavy flywheel and a high rear gear ratio, a combination of factors that combined induce large amounts of stress on the RX-7's rear axles and hubs. Mazda planned accordingly, and designed plenty of strength into the RX-7's rear differential/axles/and hubs. Experience has shown that the stock NA RX-7 components are strong enough to withstand low 10sec 1/4mi passes, a feat that requires around 500hp. "
Well, that's interesting. . .
__________________
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(active)
Motorgen Project Car
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
(back burner)
|