Quote:
Originally Posted by enkeivette
Broke off the water pump bolt, drilled a hole through the bolt perfectly, all the way through, spun in the easy-out, began to twist... and snap.
Now I'm trying to drill the easy-out, out, and it's not easy. About a 1/16" deep, drill bit is dull already... using wd40.
What do I do now?!
|
Was your easy out forged or cast? If it was forged you're probably going to need a tungsten carbide or polycrystalline diamond bit.
__________________
Motorgen on To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen on To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Motorgen Project Car To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. (active)
Motorgen Project Car To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. (back burner)
|