[BADDASSC6]

6 point Really Auto Power has a nice four point roll bar with cross bar and harness bar. I just don't like the rest of there setup. I was planning on buying that and then building the front end off of it. I helped make a full tube frame out of chromoly in college for formula SAE. It was very very time consuming, but we used very thin walled tubing and had very complicated joints (five bars in one joint) and required a .060 maximum gap in make the weld feasible. I'm not getting that fancy. But since my car is the base model and not the Z06 I was going to fabricate up mounting plates to connect the factory roll hoop and A pillars to the cage.