Motorgen - Automotive Events, Meets, Cruises and Forums - View Single Post - Getting ready for the Supercharger/ Install

enkeivette · 01-13-2008, 03:43 PM

OK... I bent and flared my own 3/8" hardline, if that's too small the next step is garden hose.

I had to move the filter down because after I moved the alternator to the passenger side I had no room for it.

So you can also see the alternator on the passenger side in these pics along with my new long water pump. You can also see (red arrow) the fitting I installed for a boost reference port on my fuel pump. (This is so that fuel will increase 1 psi for every pound of boost).

I discovered that I needed offset pulleys from ATI for the water pump and the alternator to line up with the 12 rib pulley. They are in the mail.

Lots of o-rings and silicone, I hope it seals.

We'll find out when my pulleys get here.

01-13-2008, 03:43 PM	#5
enkeivette Super Moderator Join Date: Dec 2007 Posts: 6,850 Tweet	OK... I bent and flared my own 3/8" hardline, if that's too small the next step is garden hose. I had to move the filter down because after I moved the alternator to the passenger side I had no room for it. So you can also see the alternator on the passenger side in these pics along with my new long water pump. You can also see (red arrow) the fitting I installed for a boost reference port on my fuel pump. (This is so that fuel will increase 1 psi for every pound of boost). I discovered that I needed offset pulleys from ATI for the water pump and the alternator to line up with the 12 rib pulley. They are in the mail. Lots of o-rings and silicone, I hope it seals. We'll find out when my pulleys get here.