Quote:
Originally Posted by heypal
I have my heads of now lets do port class lol.
|
I believe Glenn is going to do one. I've actually ported heads before. I ported a set of cast iron SBC and a set of cast iron BBC oval ports. These however are Edelbrock Performer RPM 6055 that I paid $2500 and are aluminum so I don't want to mess them up. The shap of the ports are pretty good as cast and only need a little porting. The aluminum is easier to remove than the cast iron was too so it's going a lot fast. I has taken me about two hours to complete one cylinder. I just hope I do a good enough job to drop 2 tenths or so so that I can get into the 9's.