Quote:
Originally Posted by enkeivette
Not what I've been told, but it's not going to hurt anything.
I've been told, epoxy, the surfacer, then glaze & sand, then spot prime & sand, then seal...
I skipped the first step. I didn't see the need for an epoxy base, seeing as how I went to bare SMC & the surfacer that I used is a polyester surfacer.
|
Ok i think you and I are on the same wave length here but have a different terminology for the products.
Except for the GLAZE & Sand,what are you doing here
i have not herd of the Glaze,can you explain what it is
Remember i am a NOOB at this
