Motorgen - Automotive Events, Meets, Cruises and Forums

Page 3 of 3

Show 40 post(s) from this thread on one page

Motorgen - Automotive Events, Meets, Cruises and Forums (http://www.motorgen.com/forum/index.php)

- Body Work, Paint, Detailing & Fabrication (http://www.motorgen.com/forum/forumdisplay.php?f=99)

- - SRT Stripes Vote (http://www.motorgen.com/forum/showthread.php?t=46143)

enkeivette

02-10-2013 09:44 AM

1 Attachment(s)

More taper. I think this looks a lot better. Attachment 782

Leedom

02-10-2013 10:37 AM

I like it with more taper too. It looks like the points on the outer stripes are lined up pretty good with the edge of the license plate edge. I think that is the best way to do it. I say the inside edge of the outer stripe is lined up with the edge of the recess.

enkeivette

02-10-2013 10:41 AM

Oh, I just eyeballed this. Just to show the idea on the car. When its ready for paint itll be sanded and Ill use blue sharp edge tape and check the symmetry with a ruler.

Shaolin Crane

02-10-2013 12:50 PM

Quote:

Originally Posted by enkeivette (Post 110948)

Attachment 780

So she decided to go with the 1st one, but after laying the tape down a few times she decided to go slightly narrower.

But the issue now is, the stripe is so damn fat at the top of the hood, when I follow it straight back it is fucking wide... like too wide. Suggestions? Thoughts?

Attachment 781

I know on the mustangs and camaros when stripes are added the ones the hit the roof are usually wider by an inch on the outside edge to allow the eye to follow the stripes properly

All times are GMT -7. The time now is 05:59 AM.

Page 3 of 3

Show 40 post(s) from this thread on one page