Ring gap changed to boost specs when I replaced all the moly rings with stainless. (Compression was the same with both rings sets).
Valves are adjusted pinky tight to zero lash, quarter turn of preload. Pushrod height and valve tip wear pattern checked when I installed the 1.65 harland sharp rockers. I did NOT over-tighten them, I am very aware of that mistake. (Compression was the same before and after different rockers). Static compression, no, absolutely not sure. The history of this motor is that I relied on the machine shops calculation to yield 10.5+:1 compression, NA cam, dynoed it, down on power. Did the math myself after measuring piston depth with a feeler guage (pistons are relieved, heads are 74cc), calculated 9.4:1. Installed a blower, kept breaking pistons. Went with a thicker HG to drop it to a then calculated 9:1, saying bye bye to proper quench, and hello to functionality. (The closest I've been since the machine shop math blunder). The end. |
Reading through this whole thing a couple times, I think your problem is as simple as the carb itself. You said you cleaned it, but is it possible you put it back together not quite right?
|
Quote:
So while 10.5:1, 9.4:1, 9:1 might be close, when you get precise you'll find out that it is probably closer to 8.6-8.8:1 which there is nothing wrong with, would explain why it runs better at that compression with the cam you currently have. |
Guy,
8.6 would not surprise me at all. In fact it would explain the low compression gauge reading, and the tolerance of my 4032 pistons with that much boost ya? Plus, I gapped my rings on the conservative end for boost specs. What about my cam would be better off with low comp? Damian, Solved the problem. It was having severely oil fouled spark plugs on the left bank. Runs like a champ now. |
Quote:
http://www.hotrod.com/how-to/engine/...ne-angle-tech/ The dumbed down version is, your cam is meant to make good power N/A so cylinder pressures will reflect that, cycle compression will be higher, so add in boost, you either add octane, or pull timing and/or compression. Right now your compression, boost and engine is very much like a pro drag motor. They don't give much of a shit about "driveability" just "engine pressures". |
Here ya go, a good thread with discussion of Vizards cams
http://ls1tech.com/forums/forced-ind...reversion.html |
All times are GMT -7. The time now is 01:12 AM. |
Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.