Chevy Small Block Alum Heads
 

Now that I'm building engines again, I"m working deals here and there.


I can get SB Alum heads for the 1st and 2d gen engine for $683.00 to your door. That is my cost.

180 cc intake runner
64 cc chamber.

That is complete ready to run.

This is for Motorgen people.

Yes, these are the same heads that are on the Vette engine in my Avatar.

Great deal. You should charge a little more and put some scratch in your pocket, it's still a great deal. Unless your Vette runs on peaches and sunshine. :smack:

Peaches and Sunshine--how did you know?:motorsmile:

I thought that is what Glen was made of. :rolling:

Sure, Glenn is fuzzy like a peach haha

Me too. I thought the Vette ran on rainbows and unicorns.

Glen, is it just SBC heads that you can get or can you get SBF and BBC as well?

Yes I get SBF and BBC heads. Don't know the prices yet. If you are interested I'll talk to them.

What brand? Hopefully not procomp :(

Tri State Racing Cylinder Heads call them "Flow-Tek"s. They machine them in house and I can pick the spings I want.


This is a China cast. Been running mine for 5 years now. All I did was port them some.:ugh:

Hmmmm, I was tossong around ideas for a cheap set of heads with an si-trim for the 88, on the other hand, I put the 348 in that car and go ls7 on the 87 :huh: