94cobra69ss396 |
03-12-2009 10:41 PM |
I've been working on the motor mounts this week after work and almost have them done. I just need to re-angle the one on the passenger side because I had the drivers side a 1/4 inch lower than the passenger side when I made the mount so the angle is just slightly off. I just need to cut the base plate and reweld it and then paint them both.
I also had to move the engine forward from where I had it originally because the rack and pinion wouldn't clear the oil pan and the engine was too high. I moved it forward so that the back of the engine is exactly the same distance from the firewall (2.5 in.) as it is in my Cobra. That means I also have to redo the trans crossmember because it is too far back. I'll take some pictures of it tomorrow while I'm working on it and post them up.
Ben, I'm hoping to have everything finished tomorrow night so that I can bring the car back to you on Saturday. Are you going to be around?
|