Ron, I can pick up the solid motor mounts that are intended for that cradle and SBC next week if you're interested.

Sure.

Can't remember what we're looking for but I figured it couldn't hurt to post it.



$600 Shipped, looks like it's new from the description.
http://cgi.ebay.com/ebaymotors/MP112...4506.m20.l1116

I did look at an even consider these early on. But
- it's smaller displacement than what we have
- it'd require a custom intake
- it'd require an offset dive for the Dizzy (they do exist)
- figuring out the rest of the front drive tensioner setup etc.

Dare I say this? Crank trigger would do away with the dizzy.

Before we punt, lets have Tom look at the broken stuff.:rolleyes:

POS:D

Ahem. You buyin????:judge:

Ditto.

No, not buying. It just brought it up. Just throwing it out there. Just letting you know.........................:leaving:

Talked to my brother last night. The School of Design at CSLB is getting a laser scanner and it should be up and running in about 3 weeks. At this time, unless someone can come up with used parts (I'm done looking), we're going to try this process before fabbing the one we have back together.

a- piece back together parts into semblance of whole
b- laser scan parts for dimensioning
c- build SolidWorks model from laser dimensioning
d- convert SolidWorks model to CNC using MasterCam
e- mill new pieces from billet

Normally this would be VERY expensive if you were going to a shop that had these resources. The only thing I'll have to pay for is the billet and actual machine time, maybe a couple hundred bucks.