Holy shit, why so much? I grabbed a set from dick for cheap.
|
That's the same price that the Mahle rings were. The only ones for $20 were for a single cylinder.
|
The set I bought were $22 from dick for the sealed power ones which are the same rings
|
I received my adjustable timing set, new rocker arm and Summit cam degreeing kit yesterday. My new rings, ring file and ring compressor just arrived so I should be able to get a lot done this weekend.
|
I was able to file fit the new rings, install them on the pistons and the install the pistons in the block tonight. The new Total Seal rings show to set the top ring at .0055 x bore, the second ring at .0035 x bore and the oil ring at a minimum of .015. So I set the top rings at .023, the second rings at .016 and the oil rings were .016 out of the box.
|
Oil rings arent so important, mostly because of the size. Looked into mine, they were .022 and .018 BTW.
|
These rings are so much nicer than the Mahle ones. The Mahle rings had a starting gap anywhere between .008 up to .015 out of the box. The Total Seal rings were .007 on every top ring, .005 on every bottom ring and .016 on every oil ring out of the box.
Quote:
|
Quote:
|
I tried calling you back but my phone died. When I went to charge it I realized i left my charger with Vanessa. I'll talk to Dick on monday about his methods.
|
I pulled the cam and installed the stock Cobra one to check about the funky .002 on the intake and the stock cam stayed at 0 until the lobe started lifting it and once closed it stayed at 0. The exhaust lobe was the same. Then I installed the ACC cam and it still did the same thing. I checked the exhaust and it is also ground funky. It stays open .001 until a few degrees before TDC and then closes back to 0. I ended up installing it 2 degrees advanced for all the numbers below. This is what I came up with.
Intake Lift - .328 Exhaust Lift - .327 Intake CL - 116* Exhaust CL - 114* LSA 115* IO - (-5*) IC - 47* EO - 43* EC - 1* Duration at .050 In 222* / Ex 224* |
All times are GMT -7. The time now is 10:17 PM. |
Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.