The balljoints on the foxes are different then the SN cars, I believe they are longer so a spacer is needed so the spindle torques down properly. Or swap out the balljoints for the steeda units

Some grade 8 washers will take care of that.

They should, though i dont think they make washers with an OD that small. It wouldnt be good if the washers were limiting the motion of the balljoint. However the spacers are only $20 shipped. About what eight grade 8 washer would cost.

Link for the spacers? I'll just buy them and have them drop shipped to John.

http://forums.corral.net/forums/susp...rakes-fox.html
Seems I was wrong. They're $12.50 for 1 set and $20 for 2 sets. If you'd like to order 2 sets we can split the cost. I've been meaning to order them, i've just been lazy.

He's probably not going to split shipping destinations, ok if it goes to John and you pick it up whenever/wherever? How you wanna do that bit?

That's fine, I cant use them without a car anyhow.

You got PayPal. I'll bill you 50% of whatever the final is (e.g., $10 I guess.)

Sounds good.

Ordered. Both sets are on their way to John's. Guy, PayPal me $10. You have my email.