Rear Seats are finished, shitty pic warning
Still fucking with the "trunk" area. Made a Deck out of plywood for the sub to rest on, but it sits too high, going to try and move the bars I made down so it sits more flush, then i'll toss a little extra padding under the carpet to hide the lines |
I had a few hours to tinker today...
|
Looks good Guy. I wish the Cobra had enough room to fit an aftercooler.
|
I've seen people fit them using the sn hardware but I have no idea how. This thing is crammed in there as it is. I doubt it was truly meant to run with smog equipment. Cause it really interferes with the diverter tubes.
|
Found the thread! 38 pages late! Haha. Is that an air to water intercooler? Get it fired up yet?
Ron, make room. You can cut, and you can weld, figure it out :) |
Looks good Guy and Ron how about an A2A fmic? My buddy is running one on his 98 g trim Camaro. I had one on the impala and it makes a huge difference:). Might have to get a bit "creative" with piping and routing but I don't think you'll have a problem with that.
|
There just isn't enough room to fit one.
|
He's right, he cant run a cooler if he wants to retain all the accessories. Any A2A cooler needs a drivers side mount which means he'd lose either power steering or A/C. He cant switch to a fox TB setup or he'd lose his cruise control.
|
Quote:
|
Quote:
|
All times are GMT -7. The time now is 02:32 PM. |
Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.