I'm working on different layouts of the two cameras to get something a bit slicker. Patience please.

What I wanted to do, while kinda possible, would take A LOT of time. See another test run of what I'm thinking of doing now in the first post.

Looks great to me :)


Hey i found out my tire size is...

Factory Wheel+Tire = 245/45/18 = 26.68 = Radius: 13.34


I'll find out the axel size later

**Subscribed**


Waiting patiently for the videos.

I had my Camera charged up and ready to go...but in my infinite wisdom, I left it at home...

Factory Wheel+Tire = 245/45/18 = 26.68 = Radius: 13.34

GXP's stock rear end is 3.73:1



Which measurement in particular were you talking about when you asked for axel size ? Pinion?

I asked Greg for a new dyno sheet for you but I'm not sure he's seen the post yet. I'll continue to try to get a new one for you with RPM's in place of MPH. :drink:

Sweet, thank you very much :woot:
Yes it did seem odd to see MPH and not RPM

Are those vids coming out in the dyno order? Because I think I'm next...

Yes.

Check Test Run 3. This is based on some suggestions by Leedom. I wish I had a graphic of the dyno sheets. The video shot of the screen (which was connected by like 50 feet of VGA cable) just doesn't look so hot. After some filters the curve is clear enough, but we aren't going to be able to make out the numbers.