My next mod is a ported FAST 102mm intake with a NW 102MM tb.

Oh how I wish if only it didnt cost a fortune!

http://www.shiftkits.com.au/index.ph...products_id=36

So this should make Ron and Nate happy, picked this up today. My wrinkle finish powder coat should be here tomorrow, so i'l start blasting it in prep to powder coat it.

I see nothing.

Really? Cause i can see it. let me try again

Next mod now is Struts for the front.

How did the pan hard line up? How does the rear feel compared to before? I know on mine it made a huge difference.

I am sure I will start a thread regarding the ordeal with the installation, but long story short... original location was correct but I thought it was off when we were installing it so we mounted it wrong because of me. So yesterday my dad and I mounted it up in the correct location and the preload on the uppers got messed up so I did not have time to loosen and retighten them yesterday and could not drive it (damn rain and darkness last night). The exhaust needs to be reworked as well so I have not driven it yet all assembled so I will let you know when I do.

Man I still think it was my fault, next time i'll leave the chatty kathy for afterwards so there is no in work confusion.

But im glad everything worked out the way it needed to in the end

Just installed stainless brake lines on my car. But I have not tested them because I lowered my coilovers to much and now im stuck in the garage til I raise them back up.