Roller paint job.

[enkeivette]

In case you guys still haven't seen this.

http://board.moparts.org/ubbthreads/showflat.php?Cat=0&Number=2331682&page=0&fpart=1&vc=1

I saw a C3 that was done in yellow, I was impressed, but not enough to do it to Cambria.

I am however going to spray the Neon front bumper with this stuff. Not roll it on, but I'll use the same paint because I'm cheap. And it's a Neon.

Done with a foam roller.
http://i32.photobucket.com/albums/d13/69martin/DSC02769.jpg

[Leedom]

Not bad. Might have to try that on the fenders of the truck.

[enkeivette]

it's all about the thinning and the wetsanding. How old is your truck? Is it white or black?

[enkeivette]

I did it, I used the $8 Home Depot paint. I had to thin is a lot with acetone. I'll let you know how it looks tomorrow.

http://sphotos.ak.fbcdn.net/hphotos-ak-snc3/hs595.snc3/31386_615075975850_19912599_35143947_2246068_n.jpg

[enkeivette]

Can you tell which panel has $8 tractor paint on it? Hahahaha.

http://sphotos.ak.fbcdn.net/hphotos-ak-ash1/hs535.ash1/31386_615118475680_19912599_35146395_3484991_n.jpg

[Vettezuki]

Can you tell which panel has $8 tractor paint on it? Hahahaha.

The one that doesn't have dirt all over it?

[Leedom]

The one that doesn't have dirt all over it?

:rolling:

[enkeivette]

The one that doesn't have dirt all over it?

I didn't think it would be difficult for you to spot, especially because there's a pic of everything but it masked off right above.

Just trying to show how nice the Home Depot enamel can look if sprayed on. Very economical and a good idea for a DD that gets hit parallel parking constantly.